RFID Card Door Access Control IC Single Door Wiegand Access Controller
Features:
Standalone, single door control.
Low Priced, connect an electric strike and power supply and you're done
No Control Panels - Standalone Access Controller
Easy and simple to use
Has a flat back so it's easy to install on any flat surface
Operating Mode: Card only, Keypad only, Card with Keypad.
Card capacity is 1600 users.
Programmable door release time: 1~250 seconds
Access code can be added or deleted by keypad management.
Built-in electric buzzer for audible card entry and programming.
Data is protected even after power failure.
Machined housing in high durable.
Mifare-IC /EM-ID thin card or keyfob optional
Specifications
Operating Voltage: DC12V
Working Current: Less than 1000mA
Capacity: 1600 PCS cards and PIN
M/ID Card format /125KHz (Mifare /IC Card /13.56MHz is option)
Door Opening Signal Output by Relay Directly(NO/NC Optional)
Size: 86*86*18(mm
Muti-fuction device,Support external wg26 card reader.
Faceplate: | Plastic or Stainless Steel |
Color: | Black or white |
Card type: | EM or Mifare |
With card control: | add/delete card |
Reading Distance: | 3-10cm |
Installation
Using "+"type screw driver to loosen the screw between the panel and motherboard. And then embed the motherboard to the side wall with the plastic plug and screws.
Wire Connection
Red DC 5V-16V
Black GND
Blue D1
White D0
Brown BEEP
Green LED
Yellow Alarm
Notice!
1. Confirm the electric voltage (DC12V) and differentiate positive anode and cathode of power supply
2. When external Power is used, make sure sharing the power with Controller Box or using the same GND
3. When the distance between card reader and controller is more than 50m, please use Power Line with at least 1.5 square cm Dia, or using several parallel Network wires.